Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Friendly Ghost FrameFriendly Ghost Frame
Level: Moderate (Requires computer skills)

Materials
3-IN-1 ADVANCED CRAFT GLUE

ZIP DRY PAPER GLUE

Wood frame, 9 1⁄2” X 7”
Air-dry paper clay
Ghost cookie cutter
Small lime green rickrack
Assorted candy bars
Orange decorative paper
3⁄4” sticky back letters to spell BOO
Black dimensional paint
Black & white 1⁄4” grosgrain ribbon
Old rolling pin or Lucite roller, computer printer & scanner, paper cutter, ruler, scissors, old credit card, pencil

Instructions:
1. Place several candy bars front down onto the scanner bed. If you want, place a clear protective cover onto the scanner before placing the candy bars; place a cloth over the candy bars while scanning onto the white cardstock paper. Print one sheet of paper or more if desired.
2. Place the frame onto the scanned candy paper and trace around the edge and photo insert using a pencil. Use the paper cutter to cut out edges and scissors to cut out the insert. Place on front of the frame. Measure up 2” from the bottom edge and draw a line across the paper. Cut paper away.
3. Cut a section of the orange paper 2” wide and 7” long. Spread ZIP DRY onto the frame front with the used credit card. Immediately place the candy paper onto the frame and then the orange paper onto the bottom edges as seen in the photo. Let dry, smoothing away any bubbles that may have formed.
4. Glue 7” length of dotted black ribbon over paper seams with 3-IN-1 ADVANCED CRAFT GLUE. Let dry.
5. Measure and cut green rickrack to go around the perimeter and edges of the frame. Glue in place with 3-IN-1 ADVANCED CRAFT GLUE.
6. While glue is drying, roll a 1/8” thick piece of paper clay and cut out the ghost shape using ghost cookie cutter. Let dry for several hours or overnight. Paint with white pearl paint. Let paint dry and then add smile and eyes using black dimensional paint. Glue to right side of the frame using in 3-IN-1 ADVANCED CRAFT GLUE.
7. Using a toothpick with a bit of 3-IN-1 GLUE, attach the stickers. Adding a bit of glue will make them hold better.
8. Finish by adding the word BOO.
Designer: Sandy Rollinger
BEACON ADHESIVES, Inc., 125 MacQuesten Parkway South, Mount Vernon, NY 10550, Tel: (914) 699-3405
E-mail: Crafts4@BeaconAdhesives.com

Beacon is not responsible for the manner in which our products are used and,
therefore, cannot guarantee results. Beacon's liability is limited to product replacement.