 Glitter & Gold Holiday Ornament
Level: Easy
Materials
GEM-TAC EMBELLISHING GLUE
DAZZLE-TAC JEWELRY GLUE
• Clear 4” diameter glass ornament
• Fine gold glitter
• Two different patterned holiday ribbons (example uses red & green plaid
• Small gold, white pearl, and amber flat back beads
• Scissors, small funnel, toothpick, small medicine cup.
|
| Instructions: |
| 1. |
Rinse out glass ornament with warm water to wash away any dust. |
| 2. |
Carefully remove the top of the ornament. Mix ½ tsp of GEM-TAC with a few drops of water, mixing with a toothpick. Mixture should be thin but not too runny. Pour mixture into ornament and shake and turn ornament to coat the inside of the ball with glue. Turn ball upside down over a paper cup to drain excess glue. Let stand about one minute. |
| 3. |
Place the funnel into opening and pour in at least ½ tsp of gold glitter. Place thumb over opening and shake until the entire inside of the ball is well coated. Let dry overnight and repeat process if any bare spots can be seen. Glue ornament top on with a little DAZZLE-TAC. |
| 4. |
Cut two lengths of the plaid ribbon and glue onto the ball using a bit of DAZZLE-TAC, crisscrossing the ribbon. Repeat process with gold and red ribbon. |
| 5. |
Apply a bead of DAZZLE-TAC between the ribbons and press on the gold, pearl, and amber beads as in the photo. Use a toothpick to gently press them in place. Repeat around the ball until complete. Glue extra beads around top to finish. Tie cord onto cap loop to hang. |
|
|
| Designer: Sandy Rollinger |
|
BEACON ADHESIVES, Inc., 125 MacQuesten Parkway South, Mount Vernon, NY 10550, Tel: (914) 699-3405
E-mail: Crafts4@BeaconAdhesives.com
Beacon is not responsible for the manner in which our products are used and,
therefore, cannot guarantee results. Beacon's liability is limited to product replacement.
|
