Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Halloween CardsHalloween Cards
Level: Easy

Materials for THE HALLOWEEN
GHOST CARD

ZIP DRY PAPER GLUE

Decorative Halloween paper with ghosts, any pattern
Black & white dotted paper
Black & white dotted ribbon, 1⁄4” wide
Yellow & orange dotted ribbon, 1⁄4” wide
Dimensional glue-in-the-dark paints
Ruler, paper cutter, scissors, pencil


.
..
More HALLOWEEN Craft Project Links:

..Sparkling Spider Treat Holder

..Friendly Ghost Frame

..Halloween Ghost Wreath

..Haunted House Box

..Trick or Treat BOO Container

..Smiling Pumpkin Candy Container

.
Materials for THE BLACK CAT CARD
ZIP DRY PAPER GLUE

5” X 7” blank white card with envelope
Copper ink
Halloween paper in orange & black
Decorative paper, black with white dots
Mustard colored cardstock
Burlap or other open weave fabric
Deckle edge scissors
Black cat and Halloween message stickers
Ruler, paper cutter, scissors, pencil


Instructions for THE BLACK CAT CARD:
1. Cut a section of the Halloween paper large enough to fit over card front and glue in place with ZIP DRY PAPER GLUE.
2. Cut a piece of dotted paper 3” X 6”, center on card front and glue in place. Cut a section of the burlap and glue it onto the dotted paper.
3. Cut a 1 ½” X 4” piece of cardstock. Trim edges with deckle scissors. Apply copper ink onto the deckled edges of the cardstock with your fingers. Glue in place over the woven fabric. Put a bit of ZIP DRY on the back of the stickers for better adhesion and place as in photo.

Instructions for THE HALLOWEEN GHOST CARD:
1. Measure & cut a 4” X 5” rectangle from the Halloween paper and glue to the top portion of the card with ZIP DRY.
2. Measure and cut a 3” X 5” rectangle from the black & white dotted paper and glue to the bottom half of the card.
3. Cut out a ghost, pumpkin and/or Halloween message from the Halloween paper and glue to the bottom of the card onto the dotted paper.
4. Cut two 5” strands of black dotted ribbon. Glue to front of the card where the paper seams meet. Cut one 5” strand or orange dotted ribbon and glue between the black ribbon as in photo.
5. Finish by adding dimensional glow-in-the-dark paints to the ghosts and pumpkins and let dry.

Designer: Sandy Rollinger
BEACON ADHESIVES, Inc., 125 MacQuesten Parkway South, Mount Vernon, NY 10550, Tel: (914) 699-3405
E-mail: Crafts4@BeaconAdhesives.com

Beacon is not responsible for the manner in which our products are used and,
therefore, cannot guarantee results. Beacon's liability is limited to product replacement.