Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Sparkling Spider Treat HolderSparkling Spider Treat Holder
Level: Easy

Materials
LIQUID LAMINATE
3-IN-1 ADVANCED CRAFT GLUE

Empty cereal box
Paper clay or other air dry clay
Green chenille stems
10mm round wiggle eyes
Purple pony beads
Orange yarn or string
Black, light purple and green acrylic paints
Purple glitter
Black & white polka dot 1” wide grosgrain ribbon
1⁄2” wide flat brush
Jar of water & paper towels for clean up, scissors, bottle caps, 1” & 2” round lids to cut out circles from the paper clay, old small rolling pin or Lucite roller, ruler, pencil with eraser.

Instructions:
1. Using old rolling pin or Lucite roller, roll out clay to about 1/8” thickness. Use a bottle cap or jar lid to make both a small and a large circle and press out. Let clay dry.
2. Paint cereal box with the black paint and let dry. Coat LIQUID LAMINATE over the front of the box and sprinkle purple glitter onto wet LIQUID LAMINATE. Let dry and gently shake loose glitter off. Let dry.
3. To create a web, make seven lines with 3-IN-1 ADVANCED CRAFT GLUE from bottom right corner and press orange string over each line of glue. Leave string ends hang over edge. After glue dries, make wavy lines with more glue between the straight lines and add more orange string. Let dry and trim all strings.
4. Paint clay circles using light purple acrylic paint. After paint dries, dip pencil eraser into the green paint and make dots on the spider’s body. Glue the small circle (head) onto the larger circle (body) with 3-IN-1 ADVANCED CRAFT GLUE. Glue on eyes.
5. Cut four green chenille stems in half for legs, curling one end. Add 4 purple pony beads to each leg. Glue other end of the leg to the back of spider. Glue spider onto web on box.
6. Finish project by gluing a ribbon handle onto the box with 3-IN-1. Continue gluing ribbon around the outside edge of the box as shown in photo.

Designer: Sandy Rollinger
BEACON ADHESIVES, Inc., 125 MacQuesten Parkway South, Mount Vernon, NY 10550, Tel: (914) 699-3405
E-mail: Crafts4@BeaconAdhesives.com

Beacon is not responsible for the manner in which our products are used and,
therefore, cannot guarantee results. Beacon's liability is limited to product replacement.