Foam-Tac

$11.99

In Stock

Hands down, Foam-Tac is the best choice for  building  and repairing all parts of foam planes including motor mounts,  control horns and rods, attaching servos, and tacking down wires.

Foam-Tac’s improved formula now contains UV blockers so that it can be used in the field in direct sunlight without any yellowing or degrading. We’ve also added a special adhesion promoter to make the glue even stronger and more durable than before.

FOAM-TAC offers many advantages over other types of glues that have been used on R/C planes. Since a little Foam-Tac goes a long way, you’ll build plane after plane with one bottle, saving time, money and materials.

Great for reattaching broken ailerons.

Won’t glue fingers together – not a cyanoacrylate.

Clear

All surfaces must be clean, dry, and free of dust and grease.

Remove white cap & save for storage.

Screw on applicator tip & snip.

Apply a thin layer of glue to each side of materials to be joined.

Wait a few seconds and then firmly press parts together and immediately separate for 4-5 seconds more.

Rejoin parts, firmly pressing surfaces together for a permanent bond.

Allow to dry for 15-20 minutes.

Full cure within 2-14 hours.

ALWAYS REPLACE THE FLAT WHITE CAP AFTER EACH USE TO KEEP GLUE FROM THICKENING!

Less is more! Apply a thin line of Foam-Tac to surfaces; add more only if needed.

Foam-Tac's bond "welds" foam together for making invisible butt-joints & seams. Once cured, bond is stronger than the foam itself. 

btt